Sygonix 2299890 Notice D'emploi page 44

• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The user transponder is now stored as a user.
• You can now add another user transponder. Simply hold it
in front of the code lock and confirm the entry as described
above.
• To end the process, hold the supplied programming
transponder (labelled "Master Add Card") in front of the RFID
sensor surface (1) on the code lock.
• The LED indicator (2) will switch to constant red to indicate
that the code lock is in standby mode.
Deleting user transponders with the "Master Delete Card"
transponder
The product comes with a special transponder labelled "Master
Delete Card". This transponder allows user transponders to be
deleted quickly and efficiently, as it is not necessary to enter
codes via the IR remote control.
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Hold the supplied delete transponder (labelled "Master Delete
Card") in front of the RFID sensor surface (1) on the code
lock.
• To delete a user transponder, hold it in front of the RFID
sensor surface (1).
44