Sygonix 2299890 Notice D'emploi page 29

• Enter a user ID (a number from
• Press the
will briefly turn green, and then orange again.
• Hold a user transponder against the RFID sensor surface
(1). The code lock will beep when the transponder has been
detected.
• The user transponder will be associated with the manually
assigned user ID.
If a transponder was not read and recognized, perform
the adding process again.
If you enter a user ID which is already assigned to a
user transponder, the adding process will fail.
A transponder that has already been added/saved
cannot be used again for another manually assigned
user ID.
• You can now add another user transponder. Enter the next
user ID manually.
• Hold the next user transponder against the RFID sensor
surface. The code lock will beep when the transponder has
been detected.
• Repeat this procedure until you have added all the required
transponders (up to 2000 user transponders are possible).
The code lock also has a function for automatically
adding a larger number of user transponders (see
section "Fourth option: Adding user transponders with
consecutive transponder numbers in series").
key to confirm the user ID. The LED indicator (2)
to ).
29