Sygonix 2299890 Notice D'emploi page 32

Example:
• Press the
code lock is now in add transponder mode.
• Enter an initial number as user ID (a number from
stored from this user ID.
Make sure that there is enough free memory for the
transponders after the first user ID, otherwise the code
lock will report an error. It would not be advisable to start
with a user ID of 1999, because manual programming
would suffice in this case.
• Press the
indicator will briefly turn green, and then orange again.
• Enter the number of transponders to be saved. Press the
key to confirm your entry. The LED indicator will briefly turn
green, and then orange again.
• Enter the first 8 or 10-digit transponder number. Press the
key to confirm your entry. The LED indicator will briefly turn
green, and then orange again.
• All user transponders from the first user ID will now be stored
as authorized transponders.
Up to 2000 transponders can be stored in one process.
The process takes about 3 minutes to complete.
• Once you have added the desired/maximum number of
transponders, press the
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
32
key. The LED indicator (2) will turn orange. The
is theoretically possible). The transponders will be
key to confirm the first user ID. The LED
key end the process. The LED
to