Sygonix 2299890 Notice D'emploi page 14

• Connect the product to the screw terminals. For more
information, refer to section 8. "a) Connection".
• Wire the connection cables according to the following circuit
examples. Ensure that there is suitable insulation (e.g. heat
shrink tubing).
• A protective diode is included for connecting a door opener.
This protects the code lock from damage caused by voltage
peaks.
• Pay attention to the correct polarity. Refer to following
connection examples (the white ring on the protective diode
must point in the direction of the positive terminal/+ when
connecting).
Caution! Never switch the mains voltage via the
potential-free changeover contact! This may cause
a fatal electric shock! Refer to the "Technical data"
section for information on the permissible contact
rating.
14