Sygonix 2299890 Notice D'emploi page 35

• To end the deletion process and exit programming mode,
press the
red to indicate that the code lock is in standby mode.
Third option: Delete the user transponder by entering the
8/10-digit transponder number
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph ".b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
will turn orange. The code lock is now in delete mode.
• To delete a user transponder, enter the 8-digit or 10-digit
transponder number. Press the
• When the transponder has been detected, the code lock will
beep and the LED indicator (2) will briefly turn green. The
LED indicator (2) will then turn orange again.
• The user transponder is now deleted.
If the transponder cannot be found in the code lock
memory, the code lock will emit 3 short beeps and the
LED indicator (2) will flash red before switching back to
orange.
• You can now delete another user transponder. Enter other
8 or 10-digit transponder numbers.
key. The LED indicator (2) will switch to constant
key on the remote control. The LED indicator (2)
key to confirm your entry.
35