Sygonix 2299890 Notice D'emploi page 28

• You can now add another user transponder. The next user ID
will be automatically assigned. You can then add additional
transponders in the same way as described above.
• Hold the next user transponder against the RFID sensor
surface. The code lock will beep when the transponder has
been detected.
• Repeat this procedure until you have added all the required
transponders (up to 2000 user transponders are possible).
• When the desired or maximum number of transponders have
been added, press the # key to finish adding the cards. The
LED indicator (2) will flash red.
• Press the * key to exit programming mode. The LED indicator
(2) will switch to constant red to indicate that the code lock is
in standby mode.
Second option: Adding a user transponder with manual
assignment of a user ID:
The code lock uses the entered user ID, which can subsequently
be used as a reference for the respective user.
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
28
key. The LED indicator (2) will turn orange. The