Sygonix 2299890 Notice D'emploi page 27

We therefore recommend that you assign a user ID for
each authorised person and enter all data (employee
name, user ID or user transponder information, etc.) in
a list.
First option: Automatically adding a user transponder
without a specific user ID
The code lock automatically uses the next available user ID, but it
is not possible to determine which one:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
Example:
• Press the
code lock is now in add transponder mode.
• Hold a user transponder against the RFID sensor surface
(1). The code lock will beep when the transponder has been
detected.
• The new user transponder will be associated with the
automatically assigned user ID.
If a transponder was not read and recognized, perform
the adding process again.
A previously added/stored transponder cannot be
assigned again to another user ID.
key. The LED indicator (2) will turn orange. The
27