Sygonix 2299890 Notice D'emploi page 31

A transponder that has already been added/saved
cannot be added again. In this case, the code lock
emits 3 short beeps and the LED indicator flashes red
before turning orange again.
• You can now add other user transponders. To do this, enter
the next 8 or 10-digit transponder number.
• Add the desired or maximum number of transponders.
• Press the
the adding process and exit programming mode. The LED
indicator (2) will switch to constant red to indicate that the
code lock is in standby mode.
Fourth option: Adding user transponders with consecutive
transponder numbers in series
If you want to store a larger number of user transponders in the
code lock and have transponders with consecutive 8 or 10-digit
transponder numbers, the code lock offers a function for this
purpose.
The transponder numbers must be continuous with
no gaps in the number sequence. Ensure that your
transponder cards meet this requirement.
Proceed as follows:
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
key to complete the process. This will end
31