Sygonix 2299890 Notice D'emploi page 24

Module miniature de contrôle d'accès rfid, protégé contre les intempéries (ip66)
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

In the following programming examples, "123456" is
used as the master code (this is the default master
code in the factory settings).
Change the master code as soon as possible – no later
than when you have finished the programming steps.
Entering programming mode:
The LED indicator (2) on the top of the code lock must turn
red to indicate that the code lock is in standby mode.
Press the
signal from the remote control, the LED indicator on the code
lock will flash red (the code lock will automatically return to
standby mode after 5 seconds without any further input (LED
indicator (2) turns red).
Enter the master code ("123456": by default):
Press the
The master code "123456" must be changed as
described in section 11 "Programming", "c) Changing
the master code" before the code lock is placed into
regular use.
The code lock will emit a beep and the LED indicator (2) will
briefly turn red. The LED indicator (2) will then turn orange.
Programming mode is now enabled.
24
key. Once the code lock has detected the IR
key to confirm your entry.

Publicité

Table des Matières
loading

Table des Matières