Installing The Receiver - Marmitek TV ANYWHERE Guide Utilisateur

4. Connect the audio/video output [D] from your extra equipment to the audio/video input [4]
of the TV Anywhere transmitter [MultiSource function]. An RCA/RCA cable [E] is supplied.
5. Connect the audio/video output [5] of the extra equipment to the audio/ video input
(SCART) [F] of your TV. To make this connection, you can use the cable you originally used
for connecting your extra equipment to your TV.
6. Insert the plug of the infrared extender cable to the output [2] on the TV Anywhere
transmitter.
7. Locate the small IR LED's on the IR sensors of the equipment connected. The IR emitters
have adhesive tape on the back. Remove the protective label and press the emitter lightly
to the front of your equipment. You may have to make some adjustments to find the right
location.
8. Select a channel using the Channel Selector slide switch [9], e.g. C.
9. Connect the power adapter to the TV Anywhere transmitter [6].
Attention: The power adapters for the transmitter and receiver are different!
10. Switch on the unit with the ON/OFF switch [7].
11. Make sure the TV Anywhere transmitter is placed some distance away from other equipment
which may interfere. Do not place the transmitter on top of your audio and/ or video
equipment.
12. Direct the flat antenna [8] at the receiver.
13. See chapter 2.3 Installing the receiver.
2.3 Installing the TV Anywhere receiver
1. Connect the RCA cable to the A/V output on the TV Anywhere receiver [15] to a TV A/V
input. Match the color of the plugs with the color code on the jacks of the receiver.
2. If connected to the Scart input use the Scart adapter marked "Receiver"
6
9
2
8
16
15
18
17
8
SAT / HDD / SETTOPBOX / DVD
7
00.00.00 12:3 4
IR LED
6
TV2
© MARMITEK