Marmitek TV ANYWHERE Guide Utilisateur page 10

! You can only access the screen below / change the handset code AFTER you programmed
the TV Anywhere .
The default setting of the remote is "0636". To change the code of both the 6in1 remote and
your TV Anywhere system:
1. Press and hold SETUP until the LED stays lit.
2. Press CBL.
3. Enter one of the following codes:
0639
0638
0637
0636 (default)
4. Switch the TV Anywhere transmitter off and then on again (by using the ON/OFF switch [7])
5. Press the SOURCE and CHAN UP buttons (right button) at the front of the transmitter at
the same time.
6. The following text will appear on your screen:
CODE WXYZ ACCEPTED
7. Press "SET". The following text will appear on your screen:
PRESS [SET] AGAIN TO
CONFIRM
8. Press "SET" again.
9. The following text will appear on your screen (where WXYZ is the new code):
HANDSET CODE 0636
PRESS [SET] TO CHANGE
OR
ANY OTHER KEY TO CONTINUE
10. Test the connection by pressing PROG+ or PROG-.
10 © MARMITEK