Setting Up The Transmitter; Setting Up The Receiver - Marmitek GIGAVIDEO580 Guide Utilisateur

3. SETTING UP THE TRANSMITTER.

See figures 1 and 3.
The transmitter can be connected to two A/V devices and a local TV.
1. Switch the Power slide switch [B] into the 'OFF' position.
2. Connect the RCA/RCA cable to the 'A/V IN 1'[C] or the Mini-DIN/RCA cable on the
'A/V IN 2' ([G]of the transmitter.
3. Connect the RCA plugs of this cable to the A/V device you want to transmit the signal
from. Make sure the colours of the plugs and the input connectors match. If the A/V
device is equipped with a scart connector you can also connect the transmitter using the
scart adapter labelled 'TRANSMITTER'.
4. In order to also connect the A/V device to 'TV1' (your local TV), insert a Mini -DIN/RCA
cable between the 'AV OUT' of the transmitter and your 'TV1'. If this TV is equipped
with a scart connector you can also connect the transmitter using the included scart
adapter labelled 'AV OUT'.
5. Set to channel selector [A] (A-B-C-D) to A.
6. Insert the plug of one of the power adapters in the 'DC in' [E] on the back of the
transmitter and plug the power adapter included into a wall socket (230V-50Hz).
Please use only the adapter provided!
7. Turn the On/Off switch [B] to 'ON'.
8. Place the transmitter in an easy accessible spot with enough space around it. Aim the
inside (flat side) of the dish antenna [K] at the location of the receiver.
9. Put the side antenna [J] in an upright position.
10. Repeat steps 1 to 3 to set up the second A/V device and then turn the On/Off switch [B]
to 'ON' again.
Video signal and S-VIDEO signal
The connector on the back of the transmitter is no S-VIDEO connector. This is why you can't
connect S-VIDEO signals to the Marmitek GigaVideo580™ but only 'ordinary' video signals. If
you only have S-VIDEO output on your A/V device or PC (you can recognize an S-VIDEO con-
nection by a small round mini DIN plug with 4 pins), then you can use the Marmitek S-VIDEO
to composite video adapter (art. no. 09388, not included).

4. SETTING UP THE RECEIVER.

See figures 2 and 4.
1. Turn the On/Off switch [B] to 'OFF'.
2. Connect the Mini-DIN/RCA cable on the outputs at the backside of the receiver [L].
3. Plug the other end of this cable into the A/V input of TV2 or the video recorder. Make
sure the colours of the plugs and the input connectors match. If the TV is equipped with
a scart connector then you can also connect the transmitter using the included scart
adapter labelled 'RECEIVER'.
Tip: The GigaVideo580 set is provided with a modulator. Using this, you can also connect
the receiver to your TV via an antenna cable. This is ideal when your TV is not provided
with a SCART input (antenna cable not additionally supplied). Link the GigaVideo580 to
your TV via the RF output [M]. During the use of the RF output, your TV should be tuned
on channel 36.
4. Insert the plug of the remaining power adapter into the DC input [E] on the back of the
receiver and plug the power adapter included into a wall socket (230V-50Hz). Please use
only the adapter provided!
5. Turn the On/Off switch [B] to 'ON'.
6. Set to channel selector [A] (A-B-C-D) to A.
4 © MARMITEK