Universal Remote Control; Tv Anywhere Channel Setup - Marmitek TV ANYWHERE Guide Utilisateur

3. Select the corresponding channel [16] with your transmitter (set both units to e.g. "C").
4. Connect the power adapter to the TV Anywhere receiver [17].
5. Switch on the unit with the ON/OFF switch [18]. The red indicator lights up.
6. Direct the flat antenna [8] at the transmitter.
! To receive the signals from your TV Anywhere, switch the TV connected to your TV Anywhere
receiver (remote TV) on to the A/V channel (on some TV's use channel "0"). If connected and if
no channel is programmed on your TV Anywhere a blue screen will appear.

2.4 Universal Remote Control

1. Open the battery compartment on the back of the remote.
2. Insert 2 batteries (AAA size, not included). Note the correct polarity/position.
3. Close the battery compartment.

3. TV ANYWHERE CHANNEL SETUP

1. When you power up the TV Anywhere for the first time, the memory does not contain any
TV channels. In this case the unit will display the screen below:
CHOOSE YOUR TV SYSTEM
[1] PAL-BG (western EU)
[2] PAL-I (uk, irl)
[3] PAL-DK (eastern EU)
[4] SECAM-L (france)
[5] SECAM-DK (russia)
2. Press the CBL button on the TV Anywhere remote control.
3. Press button 1-5, depending on the TV system used in your country. Don't forget to aim
at the receiver when using the remote. If you don't know which TV system is used, choose
option 1 (PAL-BG).
4. You will be asked to confirm your choice. Press the Enter key (ENT) on the remote control.
If you made the wrong choice, re-enter 1, 2, 3, 4 or 5 followed by ENT.
5. The following screen is displayed:
NO TV CHANNELS
Press [SCAN] to search
6. Press SCAN to have your TV Anywhere search for channels. This procedure may take up to 7
minutes, depending on the number of channels available. The TV Anywhere will automatically
TV Anywhere™ 7