Getting Started; Installation Tips; Requirements Cat5E/6 Cable; Installing The Transmitter And Receiver - Marmitek MegaView 63 Guide Utilisateur

4 Getting started

4.1 Installation tips

• First, switch off all devices (TV and HDMI sources) before
connecting them to the MegaView 63™. If a device cannot be
turned off, please remove its plug from the wall socket.
• For the best picture and sound quality, only use High Speed
HDMI® certified cables.
• Please be careful when connecting your HDMI cables. These
can damage easily.

4.2 Requirements CAT5e/6 cable

• UTP, FTP or STP cable
• 24AWG or lower
• Solid twisted pair
• 100 ohm at 1 MHz
• RJ-45 connection according to EIA/TIA T568B standard
Please note! The CAT6 cable has better specifications than the
CAT5e, often making it possible to work with longer cable lengths.
To optimise transmission quality, use solid twisted pair CAT5e or
CAT6 cables.

4.3 Installing the transmitter and receiver

1. CAT5e/6
2. HDMI input
3. 5V DC micro USB power
4. Signal strength (equalizer)
5. HDMI output
In order to check proper functioning of the system, it is advisable
to test the set-up first using a short CAT5e/6 cable length.
6
transmitter
1
2 3
receiver
1
4
5
© MARMITEK