Idle Speed Adjustment - Yamaha RHINO 660 YXR660FAT Manuel Du Propriétaire

Table des Matières

Publicité

1. Throttle stop screw
1. Vis de butée de papillon des gaz
1. Tornillo de tope del acelerador

Idle speed adjustment

NOTE:
_
A diagnostic tachometer must be used for this pro-
cedure.
_
1. Start the engine and warm it up for a few min-
utes at approximately 1,000 to 2,000 r/min.
Occasionally rev the engine to 4,000 to 5,000
r/min. The engine is warm when it quickly re-
sponds to the throttle.
2. Remove the seats. (See page 4-43 for seat
removal and installation procedures.)
3. Remove the console. (See page 8-21 for
console removal and installation proce-
dures.)
4. Connect the tachometer to the spark plug
lead, and then set the idle to the specified
idling speed by adjusting the throttle stop
screw. Turn the screw in direction a to in-
crease the engine speed, and in direction b
to decrease the engine speed.
Specified idle speed:
1,450–1,550 r/min
8-79
EVU00810

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Table des Matières