Using / Starting Up The Primezone In The Side Table (Optional); Using / Starting Up The Primezone In The Main Barbecuing Area (Optional) - Rösle Videro G3 Mode D'emploi

Using­/­Starting­up­the­Primezone­in­the­side­table­(optional)
1. Open the lid of the Primezone before lighting it.
2. The Primezone has a grate which can be used at two different heights.
• The lower position can be used like a normal gas cooker and is suitable for preparing sauces, soups, etc.
The recommended diameter for pots and pans is 25 to 30 cm.
• The higher position is ideal for frying meat. Please insert accordingly before lighting the Primezone.
Lower position
The lid of the Primezone can only be closed when the grate is in the lower position.
3. Turn on the valve on the gas cylinder.
4. Press the control knob 13 inwards and turn it anti-clockwise to the position "MAX".
5. Now light the Primezone by pressing the electronic igniter. Keep this pressed until the igniter lights up.
6. Use a match to light the burner if the igniter does not produce a spark.
• For the lowest setting, you turn the control anti-clockwise to "MIN".
• You can now use the control knob to adjust the flame to suit your particular requirements.
• Operate the grill with the lid open for 5 minutes or until the ceramic burner is red.
• Place meat or other items for barbecuing on the grill and grill according to the recipe.
• Continue to grill depending on your taste and desired cooking level at high, medium or low tempera-
ture and turn the food often. Alternatively, place the food from the Primezone onto the main grill area,
close the lid and slow cook at 120 - 160 °.
Do not close the lid of the side burners if the grill is still in use or even hot.
Do not adjust the grate if it is hot or in use.
Do NOT use the side burners for frying as cooking with oil may lead to dangerous situations.
The infrared burner is equipped with a fat catcher tray. This can only absorb a small amount of the
dripping grease.
To avoid grease fires, the fat catcher tray must be cleaned after each use.
Using­/­Starting­up­the­Primezone­in­the­main­barbecuing­area­(optional)
1. Open the lid of the grill.
2. Turn on the valve on the gas cylinder.
3. Press the control knob 12 inwards and turn it anti-clockwise to the position "MAX" - that initiates the
ignition spark.
4. If the burner does not light immediately, turn the control back to "•", wait 3 minutes to allow the accu-
mulated gas to disperse and then repeat the lighting procedure.
5. Use a match to light the burner if the igniter does not produce a spark.
42
Upper position