Removing The Burners; Leaking Joints - Rösle Videro G3 Mode D'emploi

Masquer les pouces Voir aussi pour Videro G3:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Removing the burners

• Make sure that the grill is switched off and has cooled down completely.
• Make sure that all control knobs are set to "•" and the gas cylinder is turned off as well.
1. Lift up the grates.
2. Lift up the heat diffusers.
3. Release the clip at the back. Push the burner at the back side to the
right and in the direction to the valves. Then lift up the burner and
take it out.
4. Clean the burner as described.
5. Refitting is the reverse of the removal procedure.
Winter
Over the winter months the grill should be stored in a dry, protected
place.
Clean and dry the grates and rub a little pork fat or cooking oil into them
to prevent rusting. Wrap them in paper and store them in a dry and well-
ventilated place.
• If you have any questions or are uncertain about anything, seek ad-
vice from your gas appliance supplier or sales point.
• Regularly oil the metal parts (e.g. hinge).
• After a long period of storage, and in any case at least once during
the barbecue season, the gas hose should be checked for cracks, kinks
and other damage. If the gas hose is damaged, it must be replaced at
once.
Using for the first time after removal from storage
When you first use the gas grill again at the start of the barbecue
season or after an extended period:
• Carefully read through the instruction manual again.
• Check all gas valves, burner pipes and joints for any faults.
• Check that all burners are correctly attached.
• Check whether there is gas in the cylinder.
• Check the gas grill for any leaks using a soap-and-water solution.
• Turn all control knobs to "•" and connect the gas. Before use, make sure that all grates and hotplates
have been cleaned.
• If you follow those tips, your RÖSLE Gasgrill will give you many years of reliable service.

Leaking joints

With any outdoor appliance made of steel, occasional spots of rust on the surface are to be expected. If you
always keep your grill covered over, clean and dry then you will already have gone a long way towards pre-
venting rust.
A few tips:
• The cooking surfaces (including heat diffuser) should be kept clean and dry after barbecueing, espe-
cially after barbecueing with marinades. You should rub a little oil into the cooking surfaces after use.
• Do not leave your grill standing out in the rain.
• Do not store away your grill when it is wet. Carefully dry it first.
• Regularly remove the protective hood, both in summer and winter, so that the grill is aired out and any
accumulated moisture can be dispersed.
44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Videro g4

Table des Matières