Troubleshooting - Rösle Videro G3 Mode D'emploi

• Slight surface rusting can easily be removed with a cloth (or aluminium foil) soaked in white wine vi-
negar or with a proprietary rust remover.
• Chipped enamel can be treated with touching-up paint to cover over the bare metal exposed.

Troubleshooting

Problem
Appliance does not light, no fla-
me, burner fault
Grill does not function properly
No spark
Uneven burner flame pattern
Flash flames occur
Food burns on the grate
Leaks
Other problems not listed here
Solution
• Check whether the gas supply is turned on at the gas cylinder.
• Make sure that there is enough gas in the cylinder.
• Is there a kink in the gas hose? Straighten out the hose.
• Check whether sparks are jumping across from the electrode to the burner.
• Is it possible to light the burner with a long match? Check the igniter system.
STOP, turn off the gas cylinder and turn all gas valve controls to "•".
DO NOT smoke.
• Check all gas joints.
• Wait 3 minutes to allow the accumulated gas to disperse and then repeat the
lighting procedure.
• The burners are not properly fitted over the outlets:
Fit burner exactly over the outlets.
• Gas pipe is blocked:
Remove the gas hose from the gas grill. Turn on the gas cylinder just for a second
to remove any blockage from the hose. Turn off the gas cylinder again after a se-
cond and reconnect the gas hose to the gas grill.
• Clogged outlets:
Remove the burners as described above. Check the gas valve outlets and use a
thin metal wire to remove any residues that might be causing a blockage. Place
burner over the outlets again and check whether the burner is now functioning
properly.
• Periodically check the burner to see that it is free from insects and spiders
which may clog the gas system, deflecting gas flow. Ensure to clean venturi
pipes on burner very carefully, make sure that there are no obstructions. We
recommend that you use a pipe cleaner to clean the venturi pipe area.
• The distance between the burner and the electrode should not be more than
5-8 mm.
• If necessary, clean electrode and readjust it.
Have the burners been cleaned? Clean the burners. Remove all residues. Do not
allow any water or cleaner to get into the burner jets.
• You may not have sufficiently preheated the grill. Preheat the grill for ap-
prox. 15 minutes with all burners lit.
• Clean the grill grates, fat catcher tray, etc. so that all fat deposits are remo-
ved.
Your grill temperature is too low. Wait a few minutes before turning the food so
it has time to cook properly.
• Turn off the gas cylinder.
• Ventilate the area so that any accumulated gas can completely disperse.
• Check all gas joints.
• If there is a leak, stand the gas cylinder upright in an open space.
• Keep well away from any gas or liquid escaping from the cylinder.
• Keep the gas cylinder at least 20 metres away from sources of ignition, elec-
trical appliances, flashing lights, machinery, motors or engines.
• Ensure there is maximum air circulation so that the accumulated gas disper-
ses.
Contact your specialist retailer. E-mail us at reklamation@roesle.de
45