Manual Cleaning; Decalcifying - Rotel AroMatica Mode D'emploi

300701 AroMatica755_Inhalt.qxd

Manual cleaning

If you want, you may start the cleaning program without a prior alarm showing:
• Press the programming button P in order to start program mode.
• Press the > button until the display shows select cLEANING.
• Press the ok button. The display shows manual cleaning
• Press the ok button. The display shows EMPTY trays alternating with FILL WATER.
• Continue as above for «Remove the drip pan (9b)...»
☛
If you start the manual cleaning program by accident, you may interrupt it by
pressing the power switch (7) for ca. 2 sec.

5.4 Decalcifying

If your coffee machine must be decalcified, please descale appears in the display and
the service button (2) blinks.
TIP: Press the service button only if you would like to start decalcifying.
☛
You can continue to brew coffee or draw hot water and steam. However, we
recommend that you run the decalcifying program as soon as possible.
Caution: – You may not interrupt the decalcifying program.
– Never use vinegar or acidic liquids for decalcifying your coffee machine;
• Press the service button (2) ca. 2 sec. The display shows EMPTY trays.
• Empty the drip tray (9b) and slide it back in. The display shows remove TANK.
• Remove the water tank (17).Display shows Fill water alternating with descaler in tank
• Fill it with decalcifying liquid along with the correct amount of water (follow the
manufacturer's instructions) to fill it ONLY to the 0.5 l mark.
• Replace the tank. The display shows TURN valve.
TIP: Place a sufficiently large receptacle (ca. 0.5 l) under the steam/hot water jet (12).
• Open the steam/hot water dial (11) by turning clockwise.
• The coffee machine will automatically decalcify and the solution will flow through
the hot water jet (12) at intervals (ca. 10 min.).
• Wait until the next message appears in the display: TURN valve.
• Close the dial (11) again by turning it counterclockwise.
• The decalcifying solution will now flow through the inner outlet in intervals (ca. 15 min.).
• Wait until the next message appears in the display: EMPTY trays.
• Empty the drip tray (9b). The display shows FILL WATER.
• Fill the water tank (17) with fresh water. The display shows TURN Valve.
• Open the dial (11) by turning it clockwise.
• The system will be rinsed again through the steam/hot water jet (12) in intervals
(ca. 5 min.). The display shows TURN Valve.
• Close the dial (11) again by turning it counterclockwise.
• The system is rinsed through the inner outlet in intervals (ca. 5 min.). The display
shows EMPTY trays.
38
21.9.2010
only use «Calc Clean» or a similar product.
13:40 Uhr Seite 38