Manual Decalcifying; General Cleaning; Cleaning The Central Unit - Rotel AroMatica Mode D'emploi

300701 AroMatica755_Inhalt.qxd
• Empty the drip tray (9b) and reinsert it. The system will heat up briefly. The display
shows PLEASE RINSE and the service button (2) blinks.
• Press the service button (2) and the system will be rinsed through the coffee outlet (8).
• Your coffee machine is ready for operation again.

Manual decalcifying

If you want, you may start the decalcifying program without a prior alarm showing:
• Press the programming button P in order to start program mode.
• Press the > button until the display shows select DEscaling.
• Press the ok button. The display shows Manual descaling.
• Press the ok button. The display shows EMPTY trays.
• Continue as above for «Empty the drip tray (9b)...».
☛
If you start the manual decalcifying program by accident, you may interrupt it
by pressing the power switch (7) for a few seconds.

5.5 General cleaning

☛
Never immerse the coffee machine in water.
☛
Never use a scrubbing cleaner to clean the coffee machine.
• Use a soft, damp cloth to clean the inside and outside of the case.
• Empty the drip tray (9b) and the grounds holder (9c) only when the display indicates
this. From time to time, use soapy water for cleaning.
☛
When cleaning the drip tray (9b), make sure that the two contacts (9d) at the
back of the tray are always clean.
• The water tank should be rinsed out daily and filled with fresh, cool water.
• Clean the hot water/steam jet with a moist cloth or flush it out with fresh, cold water
until it is completely clean (see also cleaning note under point 3.8)

Cleaning the central unit

Where required the central unit can be taken out and cleaned under running water. For
this use no cleaning agent, only water!
☛
We recommend you to clean the central unit once a month.
Caution: The appliance must be switched off for cleaning!
• Remove the right hand cover (13) by unscrewing both screws (e.g. with a coin).
• Disengage the central unit (24) by pressing the red switch lever and turning the
handle to the left as far as the stop.
• Withdraw the central unit carefully from the housing by the handle.
• Clean the central unit under running water. Thoroughly rinse out the milling works
and the mesh screen. Afterwards allow the central unit to dry out.
• Push the central unit carefully back into the housing and engage it by pressing the
red switch lever and turning the handle to the right as far as the stop.
• Replace the cover and screw the screws back in.
21.9.2010 13:40 Uhr Seite 39
39