Delay Function; Cleaning And Maintenance - Rotel U207CH1 Mode D'emploi

• DELAY FUNCTION

If you wish to start the brewing automatically, e.g. 06:00 in the morning, you can set the
automatic start function, after following steps 1 to 6 of section "USING YOUR COFFEE MAK-
ER", as follows:
o
Press "PROGRAM" button one time, the LED will illuminate in green and flash
(means the coffee make entered the presetting time mode).
o
Note: The time cycle is 12 hours.
o
Set the desired starting time by pressing "HOUR" and "MINUTE" button repeatedly,
e.g. to AM 06:00.
o
Press the "DELAY BREW" button, the LED is illuminated in green. After a while, the
LCD will display the current time.
o
Note: You may cancel the automatic start function by pressing "ON/OFF" or "DELAY
BREW". If you want to change the automatic start time, follow the above steps 1 to
4 again.
o
When the time is due, the LED will illuminate in red and the appliance starts brew-
ing. When the process is finished, if you do not want to serve immediately, keep the
coffee maker energised, so the coffee will be kept warm on the warming plate. The
appliance will switch off automatically after 40 minutes, if it has not been manually
disconnected after the completion of brewing. For an optimum coffee taste, serve it
just after brewing.
o
Note: During brewing process, the buttons of "PROGRAM", "DELAY BREW", "HOUR"
and "MINUTE" are invalid.

• CLEANING AND MAINTENANCE

o
Clean all detachable parts after each use in warm detergent water.
o
Wipe the exterior surface of unit with a soft, damp cloth to remove stains.
o
If condensation accumulates on the filter housing, it does not indicate that the cof-
fee machine is defective. Wipe off the area with a clean, dry cloth after each use.
o
Use a damp cloth to gently wipe the warming plate. Never use abrasive cleaner to
clean it.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
35