Manual Cleaning; Decalcifying - Rotel U27.25 Mode D'emploi

310324 rotel_U2725_U2730_inhalt_Rotel_Adagio277_Content

Manual cleaning

Where required the cleaning program can also be started and performed as described
above, without the prior appearance of an indication.

5.3 Decalcifying

If your coffee machine must be decalcified, the symbol will appears.
• You can continue to brew coffee or draw hot water and steam. However, we recom-
mend that you run the decalcifying program as soon as possible.
• The machine must be decalcified even if you are using a filter (see chapter 5.1).
Be sure to remove the filter before executing the decalcifying process.
Caution: – You may not interrupt the decalcifying program.
– Never use vinegar or acidic liquids for decalcifying your coffee
– Throughout the process the symbol is blinking.
– Please follow the stated sequence exactly.
• Turn your machine ON using the on/off button (13).
• Press the coffee strength button (3) and the 2-cup button (5) simultaneously for ca.
4 seconds.
• The symbol
• Remove and clean the drip pan (10b) and the grounds container (10c) and then
replace them both.
• The symbol and the 1-cup button (4) blink.
• Remove the water tank (16) and fill with a decalcifying agent and fresh water in a
proportion of 1:1 up to the 0.5 l mark (comply with any manufacturer's instructions).
• Replace the water tank and now press the blinking 1-cup button (4), (the symbol
blinks until the 1-cup button (4) is pressed).
• The appliance is decalcified automatically and the decalcifying solution flows through
the internal outlet at intervals (ca. 12 min).
• The symbol blinks.
TIP: Place a sufficiently large receptacle (ca. 0.5 l) under the steam/hot water jet (8).
• Open the steam/hot water rotary knob (7) by turning it clockwise.
• The residual decalcifying solution flows at intervals through the hot water nozzle (8)
(ca. 10 min.).
• The symbol
• Remove and clean the drip pan (10) and then replace it.
• The symbol and the 1-cup button (4) blink.
• Remove and clean the water tank (16), fill it with fresh water and replace it.
TIP: Place a sufficiently large receptacle (ca. 0.5 l) under the steam/hot water jet (8).
• Press now the blinking 1-cup button (4).
• The rinsing via the hot water nozzle (8) continues.
• The symbol is blinking.
• Turn off the steam/hot water rotary knob (7) by turning it counterclockwise.
machine; only use «Calc Clean» or a similar product.
lights, and the symbol blinks.
lights as soon as the cycle has ended.
13.05.11 09:18 Seite 31
31