☛
You can continue to brew coffee or draw hot water and steam. However, we
recommend that you run the cleaning program as soon as possible.
Caution: You may not interrupt the cleaning program.
• Press the service button (7) ca. 4 sec. The
• Remove the drip pan (9b) and the water tank (17) and clean everything.
• Fill the tank with fresh water and replace it as well as the pan.
• The coffee machine will rinse briefly and the
TIP: Place a sufficiently large receptacle (ca. 0,5 l) under the coffee outlet (8).
• Place a cleaning tablet into the drawer for coffee grounds (20) and close the cover.
The service button (7) blinks.
• Press the service button (7).
• The cleaning process will begin in the coffee machine.
• The cleaning process runs automatically and lasts about 10 minutes. The
bol blinks as soon as the cycle has ended.
• Empty the drip pan (9b) and insert it again.
• Fill the water tank (17) with fresh water again if necessary.
• The coffee machine will heat up briefly and then is ready for operation.
Manual cleaning
If you want, you may start the cleaning program without a prior alarm showing:
• Using the on/off button (2), switch your coffee machine ON (operation mode).
• Press the service button (7) for about 4 sec. The
one after another.
• Wait until the
The
symbol begins to blink.
• Press the service button (7) again for ca. 4 sec. The
• Continue as described above for «Remove the drip pan...»
☛
If you start the hand cleaning program by accident, you may interrupt it by pres-
sing the on/off button (2) for ca. 4 sec.
5.4 Decalcifying
If your coffee machine must be decalcified, the
and the service button (7) blinks.
TIP: Press the service button only if you would like to start decalcifying.
☛
You can continue to brew coffee or draw hot water and steam. However, we
recommend that you run the decalcifying program as soon as possible.
Caution: – You may not interrupt the decalcifying program.
– Never use vinegar or acidic liquids for decalcifying your coffee machine;
only use Durgol or a similar product.
symbol lights up and press the service button (7) briefly to confirm.
symbol blinks.
symbol will begin to blink.
and/or
symbol blinks.
symbol will appear in the display
sym-
symbols light up
31