Language; Statistics; Rinsing Setting - Rotel AroMatica Mode D'emploi

300701 AroMatica755_Inhalt.qxd

4.6 Language

You can set your coffee machine for one of 16 languages: German, English, French,
Italian, Dutch, Polish, Russian, Estonian, Czech, Swedish, Danish, Lithuanian,
Hungarian, Turkish, Spanish and Portuguese.. The factory setting is German.
• Press the programming button P in order to start program mode.
• Press the > button until the display shows sprache
• Press the ok button.
• Press the > button until you see your language in the display.
• Confirm with the ok button. The display will now show LANGUAGE.
• From this point you can go directly to programming other settings or use the exit
button to leave program mode.

4.7 Statistics

In this program setting, you can read how often the following functions have been
selected: 1 CUP / 2 CUPS / Powder / TOTAL (number of cups)
WATER / STEAM / CLEANING / descaling / FIL. CHANGE
• Press the programming button P in order to start program mode.
• Press the > button until the display shows STATIStics
• Press the ok button.
• Press the > button until you see the desired message in the display.
• The ok button will return you to STATistics. from any position.
• From this point you can go directly to programming other settings or use the exit
button to leave program mode.

4.8 Rinsing setting

The rinsing program is pre-programmed and installed by the manufacturer. Each time
the appliance is turned on from idle state, it heats up and requires rinsing. This hap-
pens in order for the pipes to stay clean and that only fresh water will be used for the
coffee brewing. The rinsing requirement shows in the display and is strarted by pres-
sing the S-service button (2).
Optionally you can also program the appliance to automaticaly initiate a rinsing after
you have turned the machine off (this is not preprogrammed by the manufacturer). But
this rinsing will only be carried out if a coffee has been previously made.
• Press the programming button P in order to start program mode.
• Press the > button until the display shows Rinsing
• Press the ok button.
• Press the > button until you see yes in the display.
• Confirm with the ok button. Display shows Rinsing.
• From this point you can go directly to programming other settings or use the exit
button to leave program mode.
☛
If you have programmed the rinsing to yes don't forget to place a cup under the
coffee outlet (8) after you have turned off the appliance.
21.9.2010 13:40 Uhr Seite 35
35