Install The Stabilizer - Staufenbiel Red Bull F4U CORSAIR Instructions De Montage

EN
30

INSTALL THE STABILIZER

1. Fix the horizontal stabilizer
into place with the washer side
face up, secure it into place
using the provided self tapping
screws. Make sure it fully sea-
ted into place.
(PA 2.6 x 20mm, 2pcs)
Note: Do not over tighten
the screw, but make sure
it's tight enough.
2. Insert the foamy nose in
front of the vertical stabilizer
into the slot as the picture
shows. Make sure to insert the
foam nose on the bottom of
the vertical stabilizer into the
hole on top of the stabilizer.
3. Turn over the plane so the
bottom of the plane face up,
secure the stabilizer into place
using the provided self tapping
screws.
(PA 2.6 x 25mm, 1pcs)
Note: Make sure the vertical
stabilzer fully fitted into place.
4. Insert the Z bend of the linkage rod from the top of
the steering arm when istall the assembly. Repeat tho-
se steps in reverse to install the assembly back.
Note: Be sure to insert the linkage into the control
connector before fully fit the landing gear assembly
into place.