Test The Main Wing Electric Device - Staufenbiel Red Bull F4U CORSAIR Instructions De Montage

Table des Matières

Les langues disponibles

1. Before getting started, bind your receiver with your transmitter. Please refer to your Transmitter

Manual for proper operation.

CAUTION: To prevent personal injury, DO NOT install the propeller assembly onto the motor

shaft while testing the control surfaces. DO NOT arm the ESC and do not turn on the transmitter

until the Transmitter Manual instructs you to do so.

2. Connect the wing leads to the harness the first. Two ailerons servo parallel with two landing light

to the four way harness labeled AILE, flaps and the Nav lights to the harness labeled CH6, main

landing gears (CH5B) and the fairing door servos (CH5C) to the sequencer.

Note: Make sure the leads polarity have been correctly inserted into the socket to assure the

servo and other electronic parts works properly.

LED

AILE

AILERON

Tips: The orange and/or the

white cables aligned on the

same side when the cable

connection completed.

3. The schematic of the receiver connection