Staufenbiel Red Bull F4U CORSAIR Instructions De Montage page 38

EN
Programming Mode Audible Tones:
0 Throttle Calibration
(within the first 4 Sec.)
1 Brake
2 Battery type
3 Low Voltage Cutoff Threshold
4 Restore Factory Setup Default
5 Timing Setup
6 Soft Acceleration Start Ups
7 Governor Mode
8 Motor Rotation
9 Switching Frequency
10 Low Voltage Cutoff Type
Alert Tones:
The ESC is equipped with audible alert tones to indicate abnormal conditions at power up.
If the ESC can´t enter into working mode after powering up, indicates that you have not setup
throttle calibration.
1. Continues beeping tone (****) - indicates that throttle stick is not in the minimum position.
2. Single beeping tone followed by a one second pause (* * * *) - indicates that the battery pack
voltage is not within the acceptable range (The ESC automatically checks and verifies the bat-
tery voltage once the battery is connected).
3. A single beeping tone followed by a short pause (* * * *) - indicates that the ESC is unable to
detect the normal throttle signal from the receiver.
38
ESC INSTRUCTION
ESC Functions
Brake On/Off
NiCad
LiPo
Low 2.8V / 50%
Medium 3.0V / 60%
High 3.2V / 65%
Restore
Automatic (7-30°)
Low (7-22°)
High (22-30°)
Very Soft
Soft Acceleration
Start Acceleration
Rpm off
Heli first range
Heli second range
Positive / Reverse
8 kHz
16 kHz
Reduce Power
Hard Cut Off