Staufenbiel Red Bull F4U CORSAIR Instructions De Montage page 27

Signal wire
(orange)
L
4. Diagram for the sequencer connection. With the
chip side of the sequencer face up. CH5B for the ret-
racts CH5C for fairing door driving servos. The signal
wire of the leads (the orange wires) on the same side.
Note: All Servos and retract leads have been spe-
cially labeled for your convenience. Use the provided
Y-harness for situations where two or three servos
are controlled by one channel; for example ailerons,
landing gear and flaps. Refer the diagram above for
recommended connections.
5. Make sure the main landing gears and the faring
doors work well in order, if not, you have to check that
if the lead goes into the right port on sequencer.
6. Make sure the navigation light on port side (L) wing
tip emitting red beams, the starboard (R) is green.
Two landing light are white.
R
7. Stick Input the aileron to make sure the servos
functions well. Put the Z-bend end of the linkage into
the desired servo control horn of the main wing. It is a
tight fit and should allow the linkage move just slightly
within the hole to avoid binding up.
8. Slap the clevis into the surface control horn.
EN
27