Install The Horizontal Stabilizer - Staufenbiel EDGE 540 Instructions De Montage

EN
26

INSTALL THE HORIZONTAL STABILIZER

1. Insert the port side (left) stabilizer half into the tail
mounting slot with the Thunderbolt side face up.
2. Slide the horizontal connecting tube into the round
hole located in the stabilizer mounting slot.
3. Slide the starboard (right) stabilizer onto the tube,
make sure the stabilzer tube, the connector and the
elevator connector are interlock to the relative parts
at the same time.
4. Fully sit the rudder
into place.
5. Secure the rudder
using the provided
screws PA 3.0x15 (2
Note: Do not over
tighten the screws but
make sure it is tight
enough.
pcs.)