One Piece Main Wing Building - Staufenbiel Red Bull F4U CORSAIR Instructions De Montage

6. Now attach the aileron surface control horns to the
bottom of the lower main wing.
7. Attach the flaps
control horn the
same with the
aileron.

ONE PIECE MAIN WING BUILDING

1. Insert the in stored fiberglass tube into the socket
on the main wing root.
Note: When sliding the tubes into the wings, they
should go in easily. Do not push them farther than
they will go with little resistance. That would push
the wing tubes into the foam of the wing and prevent
them from fully inserting into the opposite wing half.
Insert the connecting tube till the white mark the fac-
tory pre spackled.
2. Connect the rest half wing to the rods, slide it in
slightly. Make sure there is no slot between this main
wing panels. If not, you have to check the obstruction
out.
EN
25