Staufenbiel Red Bull F4U CORSAIR Instructions De Montage page 35

INSTALL THE PROPELLER ASSEMBLY
CAUTION: Before testing the propeller, make sure
the tail of the plane is firmly on the ground and ensure
there are no people or objects in the range of the pro-
peller. Make sure the throttle stick and the trim on the
lowest position before plug in the battery.
1. Place two Nylon Insert Lock Nuts rightly into the hex
notch on bottom of the spinner back plate.
Note: The hub center of the backplate contain in a
hex notch.
2. Secure the hub
using the machine
screws in stored
with hub.
3. Verify the com-
pleted propeller set
installation.
4. Keyed the propeller assembly to the motor shaft,
make sure to fit the assembly into the hex nut on the
shaft, it will help to hold the assembly in fixed position
when the engine contacted.
5. Hand tighten the spinner and make sure it is tight
enough.
EN
35