Publicité
Adjustments
LATCH ADJUSTMENTS
The latch on your Kamado Joe is already preset for an ideal tension. However, if your dome is too challenging
or too easy to latch (if it almost unlatches itself), follow these instructions for any additional adjustments to
suit your personal preferences.
1. To tighten or loosen the latch setting, use a small Allen wrench.
2. Place the Allen wrench into the top of the latch and raise or lower the catch bracket.
3. This will tighten or loosen the latch setting.
Tighten or Loosen
The latch on your Kamado Joe is also adjustable left to right, if you notice the latch needs further alignment,
simply loosen the acorn nuts that hold your latch onto the grill and slide the top or bottom of the latch to
the left or right.
BAND ADJUSTMENTS
Check the position and tightness of the bands once or twice a year,
sometimes an adjustment may be needed.
Use an 8mm allen wrench and a 17 mm wrench to make sure the
Top Band
band connector nut is tight on your bands. You can find the band
connector on the rear of your grill. You should not be able to turn the
Allen wrench easily while holding the nut in place. If this nut is loose,
tighten it firmly.
If a band is not centered on the gasket material, loosen the band
enough to push it back in place. You can place a block of wood on top
Bottom Band
of the band and lightly tap the wood with a hammer until the band is
in position. Tighten the band connector as listed above.
26
Publicité
