Publicité
Adjustments
HINGE ADJUSTMENTS
The Air Lift Hinge on your Kamado Joe is already pre - adjusted for ideal balance and stability. Follow these
instructions for any additional adjustment to suit your personal preferences.
CAUTION! Air Lift Hinge is under high tension. Do NOT attempt to disassemble the hinge from your grill
without the proper hardware. See the "disengagement tool" section below.
1. Open the dome of your grill.
2. Place a 17mm wrench on the "adjustment nut" on top of the spring retainer (see Inset 1).
3. TO MAKE DOME EASIER TO RAISE: Rotate the 17 mm wrench clockwise as shown. Remove the wrench
and check the dome action for every full rotation of the nut.
4. TO MAKE DOME FEEL HEAVIER: Rotate the nut counter-clockwise. Remove the wrench and check the
dome action for every full rotation of the nut.
5. Do not ever tighten the adjustment nut so that it contacts the nut under the connector (see Inset 1).
Air Lift Hinge
HINGE SAFETY - DISENGAGEMENT TOOL
Do not attempt to disassemble the hinge or loosen the bands from your grill without the disengagement
tool kit installed. The hinge is under EXTREME tension and can be very dangerous. The disengagement tool
was provided with the purchase of your Kamado Joe.
TO INSTALL:
1. Place the spacer, then the washer, then the
hex nut on the spring retainer on the bottom
side of the hinge.
2. Installing the disengagement tool will release
all tension on the spring and allow you to
remove both the hinge and the bands safely
from the grill.
SPACER
WASHER
HEX NUT
25
Inset 1
Nut under connector
Adjustment nut
SPRING
RETAINER
Publicité
