Publicité
- Installation prescription, in force.
The appliance is supplied without the connection cable.
To install the power supply cable, proceed as follows:
Remove the back panel
Push the connection cable through the cable blocked, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
Block the cable with the cable blocked, and reassemble the back panel. The earth wire must be longer than the others
so that if the cable blocked should break, it will disconnect after the tension wires.
N.B. The connection cable must have the following characteristics: it must be at least type H05 RN-F (resistant to a
temperature of at least 150°), and must have an adequate section for the power of the appliance (see technical data table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbol
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance for the first frying, it is necessary to clean it carefully, especially the water tub (see paragraph
"cleaning and care").
Check the connection of the appliance and start it up following the instructions.
Use the appliance only under surveillance.
- Oil or fat already used are more at risk of catching fire; therefore only use fresh oil or fat for frying.
- The food to be fried must be dry; damp or wet fry cause froth and danger of overflowing.
- Also large quantities of fry cause froth. It is advisable to fry 1 Kg of food at a time.
- When the oil goes below the minimum level, fire risk is higher.
- Never start up the appliance without oil.
These frying appliances allow to fry potatoes, fish vegetables, etc.
Attention: Please refer to the user manual 563061300 DIGITAL LINE USER'S BOOKLET
The user is to have a suitable container for the emptying of the oil.
This container must be made of heat resistant material and must be constructed so that during the emptying the oil does
not overflow and is not dangerous.
It is advisable to filter the oil daily when frying is finished and to change it whenever necessary.
Turn the oil drainage tap inside the opening into a vertical position.
Pay particular attention if the oil is hot.
Important! Pay attention to the distance between the appliance and the corners of the support.
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water and
neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry cloth.
Do not use abrasive or corrosive detergents.
To make cleaning easier, the elements may be turned by 90° in an anticlockwise direction.
GB
IE
ELECTRIC CONNECTION
EQUIPOTENTIAL
.
STARTING UP
INSTRUCTIONS FOR USE
EMPTYING THE TUB
CLEANING AND MAINTENANCE
27
Publicité
