Publicité
GB
IE
IT
CH
-it occurs when the safety thermostat is activated, stopping the heating; the controller detects its activation and opens
INPUT 1 (it is always INP1 at the moment).
-it works by deactivating and preventing all settings except: LANGUAGE + OFF, the error triangle flashes and an
intermittent beep sound.
-THE FIRST ACTION IS TO TAP ON ANY POINT ON THE SCREEN, which will deactivate the beep sound and the
flashing of the error triangle
-THE MESSAGE IS RESET BY RESTARTING THE OFF/ON CONTROLLER
Safety thermostat activated, turn off and see manual
"er03"
ALL FUNCTIONS ARE SWITCHED OFF
-Active on the following products: AUTOMATIC PASTA COOKER
-"automatic control unit malfunction" message
-it occurs when there is no heating consent for 5 consecutive seconds, INPUT 3 is open, and at the same time the solenoid
valve SV1 is deactivated, INPUT 2 open.
-it works by deactivating and preventing all settings except: LANGUAGE + OFF, the error triangle flashes and an
intermittent beep sound.
-THE FIRST ACTION IS TO TAP ON ANY POINT ON THE SCREEN, which will deactivate the beep sound and the
flashing of the error triangle
-the message resets by RESTARTING the ON/OFF CONTROLLER
Failed water level reset, turn off and see manual
"er04
ALL FUNCTIONS ARE SWITCHED OFF
-Active on the following products: THERMOSTATIC APPLIANCES
-Active only below the machine SET degrees minus the hysteresis parameter, or minus PID intervention
-"heating malfunction" message
-it occurs when the following two cases occur three times in a row:
- - first: with resistor always on, after 120 seconds (parameter) the temperature rise delta is negative
- - second: with the resistor always on, after 120 seconds (parameter) the temperature rise delta is positive but 2 degrees
lower (parameter)
WARNING: switching from any negative delta to any positive delta, or vice versa, resets
81
Publicité
