1..Hex bolt
2..washer
3..spindle ring with pin
4..spindle ring
5..screw
6...spindle (upper-part) „standard
7..chip deflector
8..cutter
9..router collet nut
10..router collet
11..screw
12..spindle (uper-part) "exchange spindle)
13..router bit
17.3 Storage
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine and then store it out
of the reach of children in a dry place protected from frost and other weather influences!
17.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist
retailer, he is obliged in certain countries to dispose of your old machine
properly.
HOLZMANN MASCHINEN GmbH
To convert the exchange spindle to standard, proceed
in reverse order.
N O T E
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
Then tighten the screw (11) and secure it with the
lock nut (S). Insert and tighten the collet insert
(10), collet nut (9) and router bit (13).
39
FS160SOLID