Publicité
ELECTRICAL CONNECTION
Dangerous electrical voltage! The machine may only be connected to the mains
supply and the associated checks carried out by a qualified electrician or under the
instruction and supervision of a qualified electrician!
Immediately after making the electrical connection, check the running direction of the
band saw rollers. Observe the direction arrow on the machine. The running direction
is correct if the saw band runs from top to bottom. If this is not the case, swap two
phases, e.g: L1 and L2, on the mains plug.
HOLZMANN MASCHINEN GmbH
W A R N I N G
N O T E
www.holzmann-maschinen.at
ELECTRICAL CONNECTION
7. Assembly rubber feet
The rubber foot (1) is attached to
each corner of the machine (2).
8. Assembly switch unit
The switch unit (1) is attached to
the machine by means of four
screws (2) and nut.
(To tighten the nut, open the door
to get accesss).
9. Assembly counter and handwheel
Spindle height adjustment
By loosening the grub screw (2),
the fixing bolt (3) can be pushed
out of the counter and fixed to the
machine by means of the grub
screw (4). Then fix the handwheel
to the bolt (3) using the cap screw
(6).
The counter can still be adjusted
to the correct height by turning
the ring (8). Then tighten the
grub screw (2) so that the counter
can count the height.
32
FS160SOLID
Publicité
