Publicité
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
4. Assembly fence
Loosen the fixing screw of the
fence depth adjustment and the
fixing screw of the fence width
adjustment. Slide the fence over
the fixing plate so that the mitred
end of the stop is in the middle of
the hood.
Screw the fence firmly to the hood
using the adjusting screw. After
completing the adjustment work,
lock both fixing screws to hold the
fence in position.
5. Assembly hold down (table):
Insert the rectangular bar (1) into
the protective hood cover and lock
it with the thumbscrew. Insert the
pressure plate (3) between the
thumb screw and the rectangular
bar (1) and slide the table
pressure shoe (2) onto the
rectangular bar (1) and secure it
with the thumb screw.
6. Assembly hold dowwn (fence)
Assemble the fence hold down (5)
on the rectangular bar using the
two screws (6) as shown. Remove
the screw (7), insert the pressure
plate (3) between the thumb
screw and the rectangular bar (4)
and slide the milling fence hold
down (4) onto the rectangular bar
(1) and secure it with the thumb
screw. Reassemble the screw (7).
With correct adjustment, the
workpiece is held firmly both on
the table and on the stop
ASSEMBLY
31
FS160SOLID
Publicité
