Publicité
supply for maintenance or repair work. Before starting any work on the machine, wait until
all tools or machine parts have come to a complete standstill and secure the machine
against unintentional restarting.
12.5 Electrical Safety
Make sure that the machine is earthed.
•
Only use suitable extension cords.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with
•
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts.
Proper plugs and sockets reduce the risk of electric shock.
•
Water entry into machine increases the risk of electric shock. Do not expose machine to
•
rain or moisture.
The machine may only be used in humid environments if the power source is protected by
•
a residual current circuit breaker.
Do not use the machine if it cannot be turned on and off with the ON/OFF switch.
•
12.6 Special Safety Instructions for Woodworking machines
Work with gloves on rotating parts is not permitted!
•
During operation of the machine wood dust is generated. Therefore, connect the machine
•
to a suitable dust collection system for dust and chips during installation!
Always switch on the dust collection system before you start machining the workpiece!
•
•
Never remove sections or other parts of the workpiece from the cutting area while the
machine is running.
When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
•
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;
Excessive noise can cause hearing damage and temporary or permanent hearing loss.
•
Wear hearing protection certified to health and safety regulations to limit noise exposure.
Only use milling cutters approved for the machine!
•
At manual feed, place hands flat on the workpiece with closed fingers and feed steadily.
•
For long workpieces, use optional workpiece supports to reduce the risk of tilting.
•
12.7 Hazard Warnings
Despite their intended use, certain residual risks remain. Due to the structure and construction of
the machine, hazardous situations may occur when handling the machines.
12.7.1 Residual risk:
- Risk of injury from tools, especially when changing tools
- Risk of injury from workpieces/workpiece parts that can be thrown away
- Risk of injury due to recoil of the workpiece
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death..
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
HOLZMANN MASCHINEN GmbH
D A N G E R
W A R N I N G
C A U T I O N
www.holzmann-maschinen.at
SAFETY
28
FS160SOLID
Publicité
