Publicité
1..Hex bolt
2..washer
3..spindle ring with pin
4..spindle ring
5..screw
6...spindle (upper-part) „standard
7..chip deflector
8..cutter
9..router collet nut
10..router collet
11..screw
12..spindle (uper-part) "exchange spindle)
13..router bit
17.2.5 Changover between the two spindles
The spindle is made of two segments. The upper tool clamping area is separated and connected
to the main spindle by a screw. This two-parted design allows easy changeover between the two
spindle variants.
HOLZMANN MASCHINEN GmbH
1. Move the spindle the max. uppermost position.
2. Release the protective hood lock (A) and flip the
3. Engage spindle lock.
4. Release the fixing and slide the fences towards
5. Disassemble/Assemble spindle upper-part:
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
5. Cutter disassembly/assembly for standard
spindle
Loosen the screw (1) on the spindle using a
fork wrench.
Remove the washer (2) and the spindle rings
(3,4), clean the spindle and remove any dust
and assemble the tool. The following
instructions must also be observed.
N O T E
Make sure that the direction of rotation
is correct.
Mount the cutter as deep as possible on
the spindle to avoid vibrations. Fit the
appropriate number of spindle rings so
that there is still a minimum clamping
length of 8 mm. When installing the
cutter, put all spindle rings back on
again, observe the minimum clamping
length again and ensure that the ring
(3) with the roll pin is in the uppermost
position below the washer (2).
Close table opening as far as possible
with insert rings (4).
Then tighten screw (2). (Note the tightening
torque of 32Nm). Close the cover again and
set the fence and hold downs as well as the
correct spindle speed according to the used
tool-diameter.
6. Cutter disassemble/assemble exchange
spindle (with collets)
Loosen the collet nut (9) and remove the
tool. Insert new tool and fix with collet nut
(9) again.
ATTENTION: Loosen spindle lock before
switching on.
protective hood (B) up.
each other to gain access to the cutter/spindle.
Changing from standard (6) to exchange spindle
(12):
Loosen hexagon head screw (1), remove washer
(2), spindle rings (3,4) and cutter (8).
Using a screwdriver, remove the lock nut (S) and
replace the screw (5), loosen the upper part of the
standard spindle (6) and exchange with that of
the exchange spindle (12).
38
FS160SOLID
Publicité
