Publicité
the FLAP is closed:
the "OPEN" (22) LED lights up, a long beep is emitted
every 5 seconds, the display (12) flashes and the motor
remains off.
If you close the FLAP when the motor is running, the latter
stops:
the "OPEN" (22) LED lights up, a long beep is emitted
every 5 seconds, the display (12) flashes.
● Extraction speed (power):
The extractor is equipped with 9 levels of extraction speed
(power). Slide your fingers along the Selection area (6):
to the right to increase the extraction speed (power) (0-9);
to the left to decrease the extraction speed (power) (9-0);
Note: The product has 1 additional timed extraction speed
(power):
for 5 minutes, then the power goes back to level 9
● Timer
Activating the extractor fan Timer function:
• Select the extractor fan (speed other than 0).
• Press
(8) to access the Timer function (at any
speed)
Regulating the Timer duration:
• Press the selector
(8) to increase the automatic shut-
down time.
• press the selector
shut-down time; the display (15) will show the countdown
Note: on the side of the extractor fan display, when the
Timer is in use, the symbol
When the timer has completed the countdown, a beep
sounds (for 2 minutes, or stops when any hob key is
pressed), while the display (15) flashes with the symbol
To switch off the Timer:
• select the extraction zone
• set the value of the timer to
Note: the function remains active if no other key is pressed
in the meantime.
● Activating/Deactivating the filter saturation indicator
light.
These indicators are normally deactivated (for both the
grease filter and the activated carbon filter)
To activate them, proceed as follows:
• switch on the extractor hob by pressing
• with the extraction motor and cooking zones off, press
and hold the Selection area (7): the FILTER (17) LED and
extractor fan display (14) turn on with low brightness.
(8), to decrease the automatic
(19) is shown.
, with
(8)
ON/OFF (1);
Display (14) shows the letter
saturation indicator can be activated in this condition.
• press the Selection area (7) a second time, display (14)
shows the letter
, the activated carbon odour filter can
be activated in this condition.
• Once the filter to activate has been selected: Press the
Selection area (6) and the FILTER (17) LED together with
the LED on the display (14)
brightness, then turn off after 10 seconds indicating
successful ACTIVATION.
To deactivate them, repeat the operation described above;
the FILTER (17) LED and the LED on the display (14)
or
switch back to low brightness, then turn off after 10
seconds indicating successful DEACTIVATION.
● Filter saturation indicator
The hood indicates when maintenance is needed for the
following filters:
Activated carbon/ceramic odour filter: the FILTER (17) LED
lights up; the display (14) shows the symbol
seconds after switching on.
Grease filter: the FILTER (17) LED flashes; the display (14)
shows the symbol
● Reset filter saturation
After performing maintenance on the filters (grease and/or
carbon/ceramic), press and hold the selection area (7):
the FILTER (17) LED goes out. This resets the filter usage
counter.
Note: Repeat the operation if both filters signals are
displayed simultaneously.
● Automatic mode
The hood will turn on at the most suitable speed, adapting
the extraction capacity to the maximum cooking level used
in the cooking zones. When the hob is switched off, the
hood adapts its extraction speed, gradually decreasing it, in
order to eliminate any residual steam and odours.
To activate this function:
Press the selection area (7) briefly, the LED
will light up to indicate that the hood is working in this
mode.
18
; The grease filter
or
switch to high
per 10 seconds after switching on.
per 10
(18)
Publicité
