Publicité
cooking with large-sized pots and pans.
It is possible to use the front "Master" cooking zone in
combination with the corresponding rear "Secondary" one
(to check which zones feature this function, see the
illustrated part of this manual).
To activate the Bridge Function:
• simultaneously press both selection areas of the
cooking zones you wish to use.
• the bridge indicator
(21) of the selected cooking zones
will light up. The symbol
• using the Selection area (3) of the "Master" cooking
zone, it will be possible to set the Operating Level
(Power).
Note: to disable the Bridge Function, simply repeat the
activation procedure.
● Timer
The Timer function is a countdown that can be set, even
simultaneously, on each cooking zone.
At the end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated
acoustic signal.
To Activate/Adjust the hob Timer function:
With more than one cooking zone active, simultaneously
press
and
(8) several times until the icon
appears in the cooking zone to be timed.
If only the zone to be timed is active, simultaneously press
and
(8). The icon
With
and
(8) it will be possible to set the desired
time. Wait a few seconds for the timer to start before
performing other operations.
If desired, repeat the operation for the other cooking zones.
Note: Each cooking zone can have a different Timer set;
on the display
selected cooking zone will be shown for 10 seconds, after
which the countdown with the least remaining time will be
shown.
When the timer has completed the countdown, an acoustic
signal sounds (for 2 minutes, or stops by pressing any hob
key), while the display (15) flashes.
To switch off the Timer:
It is possible to deactivate the timer at any time by entering
the Timer menu of the desired cooking zone and pressing
key
(8), until the timer shows
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
appears on the display
(19) will appear.
(15), the countdown of the last
(15).
Note: the setting must be made with the hob switched off,
without pressing the
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press and hold the keys
beep is heard
• simultaneously scroll selection bars (3) FL and (3) RL,
from left to right until the end of the selection bars, and
hold until you hear a short beep.
• the Timer display (15) shows the symbols
indicating that the setting can be made.
Then press key
show PHA (Phase power limit):
• the display (13) of the FL zone shows the current setting:
Value
Power (KW)
7.4 KW (default setting)
4.5 KW
3.1 KW
(19)
• to change the Power Limitation settings, scroll the
selection bar (3) FL
from left to right to increase the Kw; from right to left to
decrease the Kw
• to save the selection, press the keys
1 second; a beep will sound to confirm the setting.
EXTRACTOR OPERATION
● Power-on
Press (touch)
The indicator light will turn on to indicate that the hob/
extractor is ready for use.
Press again to switch it off.
NOTE: this function has priority over all others.
● Switching the extraction system on
Touch (press) the Selection zone (6) to activate the
extractor.
Note: Extractor flap
The extractor zone is fitted with a mechanical rotating
FLAP. The FLAP must be opened before switching on
the hood to activate the extraction system. The hood
has a sensor which when the extractor is on stops the
motor automatically if the FLAP is closed. The suction
function restarts only when the FLAP is reopened.
When switching on the extractor, the motor does not start if
17
ON/OFF (1) button, when the hob
(9) +
(10), until a short
(10) and the display timer (15) will
(9) +
ON/OFF (1) hob/extractor
(10), for
Publicité
