Publicité
2 Safety
1.4
Nameplate
The device is labeled by means of a nameplate.
► For inquiries, please have at hand the device type, device number, and year of construction as
indicated on the nameplate.
Figure 1 Nameplate
2
Safety
This chapter describes the essential safety requirements and warns of residual hazards that should
be kept in mind to operate the product safely. Non-observance of the safety instructions may result
in risks to the life and health of personnel as well as cause environmental or material damage.
2.1
Designated use
The unit is used to extract fumes and dust that result from welding, grinding, and thermal cutting
processes. The unit can be used for extraction during welding, grinding or cutting steel with a
nickel and chrome alloy content less than 30 %.
The unit must not be used for extracting welding fumes that contain CMR substances.
The device may be used only for the purpose and in the manner described in this documentation.
Any other use is considered non-intended. Unauthorized conversion work or modifications to
increase performance are not permissible.
► Only operate the unit with original ABICOR BINZEL spare parts.
► Do not exceed the maximum load data given in the documents. Excess loads will lead to
irreparable damage.
► Do not make constructional changes to the unit.
► Do not use or store the unit in wet conditions.
► Only use the unit outdoors when sufficiently protected against the influences of the weather.
► Note that the volume flow routed back into the workspace must not exceed 50 % of the supply
air to the installation room. With free room ventilation, a supply air flow of one times the room
volume per hour can be assumed. This means an air exchange rate of one per hour (supply air
flow [m³/h] = Room volume [m³] × air exchange rate [1/h]).
► Check the extraction hoses for damage and soiling at regular intervals, but at least once every
week.
EN - 6
xFUME™ ADVANCED 115V – CSA
BAL.0882.0 • V01
Publicité
