Publicité
11 Faults and troubleshooting
Fault
Extraction system does not start
up.
Dust is escaping from the dust
collection bin.
Filter dedusting is not working. Compressed air supply not
Service LED illuminates
continuously.
The power LED illuminates after
initialization but the motors fail
to start.
EN - 32
xFUME™ ADVANCED 115V – CSA
Cause
Power supply not OK.
Electrical component faulty.
The carbon brushes are
defective.
Current clamp is not mounted
correctly.
Dust collection bin leaking.
Dust collection bin full.
OK.
Filter cartridges not inserted
correctly.
Rotary nozzles tilted or
damaged.
End caps of the rotary nozzles
loose or fallen off.
Filter cartridges or filter
membranes are defective/
saturated.
Control board defective.
Correction
► Check and replace as
needed, or contact customer
service ð 10.4 Replacing
the carbon brushes
(Page 29).
► Mount the current clamp
properly ð 7.2 Mounting
the Current Clamp
(Page 17).
► Check the dust collection bin
and fit it properly. ð 10.2
Emptying the dust collecting
container (Page 26)
► Empty the dust collection
bin. ð 10.2 Emptying the
dust collecting container
(Page 26)
► Check the compressed air
supply and replace if
necessary.
► Check filter cartridges for
correct placement and insert
correctly if necessary.
ð 10.3 Replacing filter
cartridges (Page 27)
► Check the rotary nozzles
and contact customer
service if necessary.
► Check the top and bottom
end caps of both rotary
nozzles and contact
customer service if
necessary.
► Set the <On/Off> switch to
<Off> to clean the filter
membrane.
The filter membranes are
cleaned twice.
► Change filter cartridges.
ð 10.3 Replacing filter
cartridges (Page 27)
► Check and replace the
control board as needed, or
contact customer service.
BAL.0882.0 • V01
Publicité
