Abicor Binzel xFUME ADVANCED 115V - CSA Mode D'emploi D'origine page 23

xFUME™ ADVANCED 115V – CSA
Set the <On/Off> switch to <On>.
2.
The filter membranes are cleaned once.
Once the welding process begins, the device
receives a signal from the current clamp and
automatically starts the fume extraction process.
9 Putting Out of Operation
Set the <On/Off> switch to <Off>.
1.
Set the <On/Off> switch to <On>.
2.
The filter membranes are cleaned once.
Set the <On/Off> switch to <Off>.
3.
Remove the current clamp from the cable
4.
assembly.
BAL.0882.0 • V01
9 Putting Out of Operation
EN - 23