Publicité
6 Transport and installation
6
Transport and installation
7
Commissioning
7.1
Attaching the extraction hose
A maximum of two fume extraction devices may be attached to the device. If only one fume
extraction device is connected, the cap for the second connector should be closed to ensure
optimal extraction.
Remove the sealing cap from the air intake
1.
fitting.
Screw the connectors on both ends of the
2.
extraction hose.
Connect one end of the extraction hose to
3.
the connection on the cable assembly of the
fume extraction device (e.g. fume extraction
torch).
Connect the other end of the extraction
4.
hose with intake nozzle to the unit.
EN - 16
Risk of injury due to improper transport and setup
Improper transport and setup can lead to the unit tilting or falling. Serious injuries can
be the result.
► Check and wear your personal protective equipment.
► Place the unit on a suitable base (level, firm, dry) so that it cannot tilt over.
► Take the weight of the unit into account when lifting the unit. ð 5 Technical data
(Page 15)
► Use suitable lifting gear with load-handling attachments to transport and set up the
unit.
► Avoid jerky lifting and set-down of the unit.
► Do not lift the unit over people or other units.
xFUME™ ADVANCED 115V – CSA
WARNING
BAL.0882.0 • V01
Publicité
