Publicité
16.3
Storage
Store the machine including accessories in a dry, frost-proof and lockable place when not in use.
Cover the machine or store it in the original box to protect it from dust. Make sure that
unauthorized persons and especially children do not have access to the machine. Disconnect
the machine from the power supply and slacken the drive belt.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4
Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual
waste. If necessary, contact your local authorities for information regarding
available disposal options.
If you purchase a new machine or equivalent equipment from your
specialist dealer, he is obliged in certain countries to dispose of your old
machine properly.
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before starting work to
repair defects and secure it against unintentional reconnection.
Many possible sources of error can be eliminated in advance if the machine is properly
connected to the power supply. If you are unable to carry out the necessary repairs properly
and/or do not have the required training, always consult a specialist to solve the problem.
Possible Errors
Trouble
motor does not run
motor overheated
excessive motor
noise
machine bogs down
during cutting
strong vibration
HOLZMANN MASCHINEN GmbH
• Slacken the drive belt by loosening the locking lever of the
motor plate (1) and lifting the belt tensioning handle (2).
WAR N I N G
Possible cause
switch defective
•
power supply switched off
•
motor overloaded
•
air flow at the motor restricted
•
defective motor
•
loose belt pulley
•
•
loose drive belt
cutting depth too great
•
defective or warped workpiece
•
worn spindle bearings
•
www.holzmann-maschinen.at
N O TE
repair switch
•
Check power supply, replace fuse or
•
switch contactor if necessary.
reduce motor load
•
Clean motor housing to regulate air
•
flow.
check the motor
•
Tighten the adjusting screw of the
•
belt pulley.
•
tighten drive belt
reduce cutting depth
•
Only use material according to
•
specifications.
•
Centre the workpiece more
accurately.
change spindle bearings
•
TROUBLESHOOTING
Solution
39
D510F_230V
Publicité
