Publicité
TRANSPORT
For proper transport, follow the instructions and information on the transport packaging
regarding center of gravity, slinging points, weight, means of transport to be used and
prescribed transport position, etc.
Transport the machine in its packaging to the place of installation. Ensure the correct body
posture when lifting, carrying and setting down the load.
Lifting/Setting down
-
When lifting/setting down, ensure that you are standing firmly (legs hip-width).
-
Lift/set down load with knees bent and back straight.
-
Do not lift/set down load with a jerk.
Carrying
-
Carry load with both hands as close to body as possible.
-
Carry load with straight back.
-
When transporting the assembled machine, ensure to lift it only by the machine body
and not by the attachments.
If you transport the machine with a vehicle, ensure that the load is secured appropriately!
ASSEMBLY
14.1
Preparation
Delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or
missing parts to your dealer or the shipping company immediately. Visible transport damage
must also be noted immediately on the delivery note in accordance with the provisions of the
warranty, otherwise the goods are deemed to have been properly accepted.
Requirements for the installation site
The chosen installation site must ensure a suitable connection to the electrical power supply
and have a connection to the extraction system. The installation site must meet the required
safety regulations and ergonomic operating conditions, such as lighting, space requirements
and working position. Place the machine on a level solid base with appropriate load-bearing
capacity for machine and workpiece. When dimensioning the required space, take into account
that the operation, maintenance and repair of the machine must be possible without restriction
at all times.
Preparation of the surface
Remove the preservative applied to protect the parts against corrosion without painting. This
can be done with the usual solvents. Do not use nitro solvents or similar agents and in no case
water.
The use of paint thinners, petrol, aggressive chemicals or scouring agents will cause
damage to the surfaces!
Therefore: Use only mild cleaning agents for cleaning!
14.2
Electrical connection
Dangerous electrical voltage!
Risk of injury due to dangerous electrical voltage!
Connecting the machine to the power supply and the associated checks may
only be carried out by a qualified electrician or under the guidance and
supervision of a qualified electrician!!
Check, whether the neutral connection and the protective grounding are working
•
properly.
Check, whether the supply voltage and the frequency correspond to the specifications of
•
the machine.
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
HOLZMANN MASCHINEN GmbH
N O TE
WAR N I N G
N O TE
www.holzmann-maschinen.at
TRANSPORT
30
D510F_230V
Publicité
