Publicité
Machine overruns!
After switching off, stay with the machine until the workpiece has come to a
standstill. Never stop the rotation by hand!
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its
safe operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
•
Remove chips and dirt particles from the machine after each use with compressed air
and a soft brush.
•
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating
oil (e.g. WD40 rust inhibitor).
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or
defects that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only original spare parts recommended by the manufacturer.
•
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions.
The following intervals apply when the machine is used within the technical limits:
Interval
before starting
work
HOLZMANN MASCHINEN GmbH
Switch on
• Press the switch-on button (1) of the switch unit.
• If necessary, set the desired spindle speed with the rotary
regulator (2) and read the set spindle speed on the digital
display (3).
Switch off
• Set the lowest spindle speed with the rotary regulator (2).
• Press the switch-off button (4) of the switch unit.
C AU TI O N
WAR N I N G
Components
• guide ways
• spur center and centre
punch tip
• motor
• cable connection
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
• oil
• Keep the tool, especially the threaded
cone, free of dust and apply a thin layer
of oil.
• Check that the ventilation slots are free
of contamination.
• Check, replace if damaged.
Action
D510F_230V
36
Publicité
