Publicité
12.3
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
•
Check the machine for completeness and function before starting. Only use the
machine if the separating and other non-separating protective devices required for
machining have are fitted.
•
Make sure that the guards are in good working order and properly maintained.
•
Select a level, vibration-free surface as the installation area.
Ensure sufficient space around the machine. Keep the area around the machine free of
•
obstacles (e.g. dust, chips, cut-off workpiece parts, etc.).
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Make sure you have a secure footing when working.
•
•
Ensure a clean working environment.
•
Only use tools that are in perfect condition and free of cracks and other defects (e.g.
deformations).
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorized restarting.
The machine may only be operated, maintained or repaired by persons who are familiar
•
and who have been informed about the dangers arising from this work.
Ensure that unauthorized persons keep a safety distance from the machine and keep
•
children away from the machine.
•
Always work with care and the necessary caution and never use excessive force.
•
Do not overload the machine.
•
Only work in well-ventilated rooms.
Hide long hair under hair protection.
•
Wear close fitting protective work clothing and suitable protective equipment (eye
•
protection, dust mask, ear protection, safety shoes).
Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
•
•
Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
•
Ensure proper connection to the dust extraction system.
•
Do not use the machine in areas where vapors of paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
Shut down the machine and disconnect it from the power supply, before adjustment,
•
changeover, cleaning, maintenance or repair work, etc. Before starting work on the
machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restart.
•
Warning signs and/or stickers on the machine that are illegible or have been removed
must be replaced immediately!
12.4
Electrical safety
Make sure that the machine is grounded.
•
•
Only use suitable extension cables.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the machine. Keep the cable away
from heat, oil, sharp edges or moving parts.
•
Proper plugs and sockets reduce the risk of electric shock.
Water entry into the machine increases the risk of electric shock. Do not expose the
•
machine to rain or moisture.
The machine may only be used if the power supply is protected by a residual current
•
circuit breaker.
Before connecting the machine always make sure that it is switched off.
•
Use the machine only when the ON-OFF switch is in good working order.
•
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
SAFETY
28
D510F_230V
Publicité
